Forum Discussion
Richard_Schmit_
Nimbostratus
NimbostratusSnat automap and pool selection based on source and destination Ip
Trying to figure out an I-rule that will work for the follwing:
I have 3 ISP’s I’m load balancing to for outbound traffic. I have specific Virtual servers set up for specific outbound traffic. ...
Michael_YatesNimbostratus
NimbostratusThe iRule will turn SNAT on and off based on the qualifying conditions in the iRule (overriding the Virtual Server Configuration), so you should not need it to be applied the the Virtual Server.
Same applies to the Pool.
The Virtual Server status will be based on the availability of the pool status in the iRule if you do remove the pool from the Virtual Server (which is probably desirable).
