Forum Discussion
Richard_Schmit_
Nimbostratus
NimbostratusSnat automap and pool selection based on source and destination Ip
Trying to figure out an I-rule that will work for the follwing:
I have 3 ISP’s I’m load balancing to for outbound traffic. I have specific Virtual servers set up for specific outbound traffic. ...
Richard_Schmit_Nimbostratus
NimbostratusI have the data class and Irule built.
Currently I have this for my configuration on the WildCard Outbound VS.
}
virtual vs-Outbound_WildCard {
snat automap
pool Pool-Outbound_EverythingElse
destination any:any
mask 0.0.0.0
persist dest_addr
vlans internal enable
}
Do I just turn snat automap off, and get rid of the pool, and call up the I-Rule instead? Leave everything else the same?
