Single Arm Design/Deployment Question

We're trying out options to replace our existing Cisco ACE architecture, it is now in bridged mode with 3 contexts for 3 different IP subnets/vlans.

 

 

How do we bring up a similar setup with F5?

 

 

Vlan 1 - 192.168.1.0/24 (both VIP & Servers in this)

 

Vlan 2 - 192.168.2.0/24 (both VIP & Servers in this)

 

Vlan 3 - 192.168.3.0/24 (both VIP & Servers in this)

 

 

Would this work if i have,

 

one interface connecting the switch,

 

a default route pointing to an interface on the switch,

 

make the switch port connecting F5 trunk

 

configure SNAT_Pool for all the Virtual Servers

 

and configure VIPs & Servers belonging to all the 3 subnets ?

 

 

Are there options to create partitions, make each function as seperate LTM (assign interfaces, resources etc) ?