Forum Discussion
Julio_Navarro
Cirrostratus
Cirrostratusshow "rule" source/destination port
Hello, I am trying to find the command that will display the different "rules" based on the VIPs. For example: source: 192.168.0.0 destination: 10.10.10.2 port 25 source: 0.0.0.0 destination: 10....
Hello Julio.
I don't know if I understand you correctly, but I think you are looking for a command to get connections table entries base on one specific VIP.
The command is this (only valid for release 11.0 and higher):
tmsh show sys connection cs-server-addr <VIP>You can find more info here:
REF - https://support.f5.com/csp/article/K53851362
KR,
Dario.
Julio_NavarroThank Dario!
The table I am looking for is not the one of active connection but more on how the LTM will accept the connections.
With no VIPs defined, the LTM will not let traffic pass through.
In the example above, if 172.16.0.1 hits 10.10.10.2, it will NEVER go to the first rule (which is port 25) and it will hit the second rule (which is port 22)
I know I have seen (long time ago). I might have confused it with an explanation on how the LTM process the requests.
But I am sure I have seen it :-)
- Julio_Navarro
Yes!!! I was not crazy after all.
(or maybe I am crazy asking...... is there a command to pull this out?)
No commands. That's the built-in behaviour :-)