Forum Discussion
Bhavik_1402
Nimbostratus
NimbostratusSelf IP in different subnet and VS and pool members are in same subnet then Self ip
Hi Team, I'm working on one of the installation where the requirement is that VS - e.g 10.10.10.X and pool members are in same subnet 10.10.10.X whereas F5 Self IPs will be in different subnet ...
Bhavik_1402Nimbostratus
NimbostratusThanks Heino,
F5 will not be router for 10.10.10.0/24 network as it will be on switch and pool members(servers) gateway will be switch so we need to use SNAT. I am still not clear on how the routing/switching or traffic will flow.
Heino
Cirrus
CirrusI seriously hope that SanjayP's answer works foryou, because I can't recommend what I'm about to reply. Absolutely avoid the following if possible. It will only give you a headache.
I've had to resolve a similar problem previously on a competing platform. It wasn't the same though. My VS was in a different subnet, I just had to SNAT to a subnet that would route differently that standard.
Traffic flow:
- I used SNAT to map the communication from reverse-proxy to the server.
- Then I used Policy Based Routing, based on source address (your SNAT pool) to ensure that that network segment is routed through your desired gateway address (10.10.20).
