Running sample SystemInfo.pl script gives 'Could not connect to the requested iControl CORBA Portal'

Did you try the above suggested restart commands:

 

 

bigstart shutdown portal

 

bigstart startup corbalocallb

 

bigstart startup corbasystem

 

bigstart startup corbanetwork

 

bigstart startup corbamgmt

 

bigstart restart httpd

 

 

I would also throw in the "bigstart restart httpd" to be safe (or a reboot would the most sure bet).

 

 

On 4.x, the iControlPortal.cgi acts as a proxy to the CORBA portal on the device. If for some reason, communication cannot be established between the iControlPortal and the local CORBA portal, this error message will occur. If this problem persists, even after a restart of all the services (or a reboot), then you will have to contact Product Technical Support to get a support engineer looking at your specific configuration.

 

 

-Joe