Problem with Redundancy Mode

RGK - I'm unfortunately booked this week but am watching this thread carefully so should be able to respond quickly -

 

 

I won't say that there's "no use for network failover" but if your units are close enough together to use serial failover, then that's the way to go - if you're using both, then both have to fail before a failover occurs. While network failover does give you more insight into whether the units have network capabilities, you can get that same information by using vlan or gateway failsafe...I recommended getting rid of the network failover for now just to see if that's what's causing the units to go active active.