Potential v10 Compatibility Issue

I just performed the following on my v10.0.1 system

 

 

1. Create an iRule (a_test).

 

2. Click Save.

 

At this point nothing is in my log and the iRule has been saved.

 

 

3. Create a second iRule

 

4. Click Save

 

This iRule is saved as well with no errors in the log.

 

 

5. Make changes to both iRules

 

6. Click Save

 

This saves the currently selected iRule.

 

 

7. Click "File.Save All"

 

This saves all modified iRules.

 

 

With regards to your log error, are you creating an iRule with the same name as one that already exists on your system? You are implying that your iRule was saved since you tried to save it again later. Is the log error include the name of the iRule you are creating (ie. DTS-CobaltIGSelection) or is it the same error regardless of the iRule you are trying to save?

 

 

What is your partition setup? Are you working in the Common Partition or a separately created one?

 

 

Also, have you tried creating the same iRule name and contents in the GUI and looked in the logs for this error? The iRule Editor is just a wrapper around the iControl interfaces and then into the mcpd database so if you are seeing this error, it would likely be seen in the GUI and CLI as well. If you could verify that it's working there but only not with the Editor, that may help narrow things down a bit.

 

 

-Joe