Forum Discussion
anshubathla
Altostratus
AltostratusOne ARM mode with pool members in different VLAN
Hi Team, I have one Virtual Server and 2 Pool members configured in the same VLAN (One arm mode) . I am using SNAT Pool of two IP's from the same subnet . This setup was working perfectly f...
Mayur_Sutare
MVP
MVPHi,
- Did you tried to telnet non-working pool member from F5 self IP as source ? If not, you can try it once using -
telnet -b Self-IP Dest-IP Port- If you have specific Route Domains, first change the route domain then telnet or try to reach pool member from there.
To change the route domain use command rdsh
- If telnet is failing in any of the above cases, you can check by adding route for the pool member host on F5 towards the gateway/IP where its L3 is configured.
anshubathlaAltostratus
AltostratusWe are able to telnet the working and non working pool members from F5.
do you think we need to change any other thing when we are using One ARM mode with VS and pool member in different VLAN while using SNAT.
