Forum Discussion

skravens_86061's avatar
skravens_86061
Icon for Nimbostratus rankNimbostratus
Nov 24, 2009

node will not take traffic when added back into pool

I have a pool of 3 nodes and I had to take it down. Well I took my last node out and placeed it back in the pool and then re-enabled the pool. Now my third node will not take traffic?     v...
config
design
hoolio's avatar
hoolio
Icon for Cirrostratus rankCirrostratus
Nov 24, 2009
You can also run bigpipe commands from the bigpipe shell in the GUI under System | Console.

 

 

Can you post anonymized copies of the VIP and pool config? Can you also check to see if there are more than two client IP addresses listed in the source address persistence records under Overview | Statistics | Statistics Type: Persistence Records or from the actual command line using 'b persist all show all'?

 

 

Thanks,

 

Aaron