Forum Discussion

skravens_86061's avatar
skravens_86061
Icon for Nimbostratus rankNimbostratus
Nov 24, 2009

node will not take traffic when added back into pool

I have a pool of 3 nodes and I had to take it down. Well I took my last node out and placeed it back in the pool and then re-enabled the pool. Now my third node will not take traffic?     v...
config
design
hoolio's avatar
hoolio
Icon for Cirrostratus rankCirrostratus
Nov 24, 2009
Is the node address enabled and marked up? How about the pool member? You can check using 'b node 1.1.1.1 show' and 'b pool POOL_NAME show'.

 

 

If both are not showing down, then it might be persistence. Which persistence method(s) are you using on the VIP? Which load balancing algorithm are you using on the pool?

 

 

Aaron