Forum Discussion
How to make outbound traffic to flow through an F5
but dont we need network connector to allow requests between both networks because in F5 documents it is mentioned as that SLI and SLO are virtual networks and virtual network is a similar concept as of VRF and network is required for communication to work ?
As I mentioned no you don’t the connectors are for cases where you need the servers on the SLI to have internet access through the SLI for example or to connect them to the XC global network as other servers on other CE to reach them and that are complex use cases that you can review with F5 sales. I suggest asking F5 sales to install a test CE for you to see it in action.
- netadmindetail_Sep 30, 2011
Nimbostratus
I means by non routable that I wasn't able to specify management interface or IP address of management's gateway when I tried to add route into GUI interface. - netadmindetail_Oct 05, 2011
Nimbostratus
Hi restarted my BIP-IP active and standby then a few hours later things started to works well. Why things doesn't start to syslog on the right interface just after the reboot, I don't know. - But my NTP packets still goes by my selfip address instead of my management address. Is this supposed to be the same ?have u added mgmt route for NTP server (similar to what Aaron suggested)? so, NTP packet would be sent throught mgmt interface.
- Yes it started at 4:02 in the morning. Why 4:00 ? logrotate is run at 4:02 daily.
- netadmindetail_Oct 24, 2011
Nimbostratus
I activate Mac Macquarading on my vlan interface.
Recent Discussions
Related Content
* Getting Started on DevCentral
* Community Guidelines
* Community Terms of Use / EULA
* Community Ranking Explained
* Community Resources
* Contact the DevCentral Team
* Update MFA on account.f5.com