Forum Discussion
NimbostratusNeed command to check full Virtual server configuration in LTM
CirrusHi,
In TMSH:
Show complete LTM configuration: 'list ltm'
Show virtual-server configuration: 'list ltm virtual [virtual-server name]'
Show pool configuration: 'list ltm pool [pool name]'
Show monitor configuration: 'list monitor [monitor name]'
You can use TAB to auto-complete the commands.
Check the correct partition before using these commands.
Regards,
Martijn
tushar2k_312391Thanks Martijn. But these are separate commands to view Virtual server, pool and monitor. I need only one command to view all these at a time for single virtual server.
- MvdG
Hi,
Basically you want the graphical output of a virtual server configured with an iApp from one CLI commando? I am not sure that is possible.
A monitor is tied to a node. That node is tied to a pool which also has a monitor. The pool is tied to a virtual-server. All seperate configuration items.
Did some testing in my lab, but could not find one single command that shows the complete virtual-server configurarion with pool, nodes and monitors.
Regards, Martijn
- tushar2k_312391
In Cisco there is a hidden command "Show run filter intxx ". Which displays full LB setup for one virtual server
- Max_Q_factor
Cirrocumulus
People have written scripts to do this - https://www.davideaves.com/2016/11/display-a-ltm-network-map-at-the-bash-shell-on-a-f5-bigip/ to view operational status
and
https://www.davideaves.com/2016/11/filter-out-a-single-f5-virtual-server-config-on-a-bigip/
to show tmsh configuration
