monitor statistics

Hi Flo,

 

 

The pool member down message will be logged when the pool member does not respond successfully to at least one monitor request during the timeout period.

 

 

Here is an explanation of the interval and timeout:

 

 

 

interval: how often in seconds to send a request

 

 

timeout: how long to wait for a successful response before marking the member down

 

 

By default, these values are set to interval and timeout of 5 sec and 16 seconds (timeout = 3 x interval + 1). So the monitoring daemon starts a timer equal to the value of the timeout. It will send a request every five seconds--the length of the interval. When it receives a successful response, the countdown is reset to the timeout value. In this scenario, the node basically has three chances to respond before being marked down. Requests are still sent every interval even when the node is marked down. This allows for automatic resumption of use of the node when it responds correctly to a request. If you want to keep the node marked down even after it responds again, you can enable 'manual resume'.

 

 

If you want to give the node more chances to respond before marking it down, you could extend the timeout length. Setting the interval and timeout to 5 and 31 would mean the node would get sent six requests before being marked down.

 

 

 

 

Aaron