Forum Discussion
JayanthLakshmipathy
Nimbostratus
NimbostratusLooking for a TMSH command to check traffic flow
Hi I have few VS configured with source, destination and port as ANY. Its an early configuration, not sure whats the background. I can see traffic on all VS statistics. Would like to check, is the...
JayanthLakshmipathy I'm not sure if a command exists that would show this because the typical connection table outputs source IP, source port, destination IP, destination port, and destination pool member. I think the only option to look at connections in a reactive way would be to perform a tcpdump with the following flags that would insert F5 information about where the traffic is going.
tcpdump -nni 0.0:nnp host <client_IP> -w /shared/tmp/my_cap.pcap
Paulius
MVP
MVPJayanthLakshmipathy I'm not sure if a command exists that would show this because the typical connection table outputs source IP, source port, destination IP, destination port, and destination pool member. I think the only option to look at connections in a reactive way would be to perform a tcpdump with the following flags that would insert F5 information about where the traffic is going.
tcpdump -nni 0.0:nnp host <client_IP> -w /shared/tmp/my_cap.pcap
JayanthLakshmipathyNimbostratus
NimbostratusHi Paulius
tcpdump, helped in getting what i need. Thanks very much.
Thank you
Jay