Forum Discussion
semperfiguy_759
Nimbostratus
Nimbostratuslink controller outbound
Is there a way, besides an iRule, to configure link controller to SNAT outbound traffic to a specific IP address on link 1 unless that link is down?
I have the following iRule on a forw...
hoolio
Cirrostratus
CirrostratusI don't think there is a way to force LC to select a specific SNAT address without using an iRule. However, if you had the two ISP links set on different VLANs and enabled SNAT automap on the VIP, LC would select the floating self IP for the egress VLAN to source the traffic from. You could use priority groups in a default gateway pool to select ISP1 by default. ISP2's gateway would only be used if ISP is marked down.
Aaron
