Forum Discussion
ringoseagull_77
Nimbostratus
NimbostratusIs it possible to change the network management interface IP remotely?
Set up: Pair of 1600s which were in active/standby mode. Active unit running 9.4.7. Standby unit running 10.1 but needs some reconfiguration to it's monitors before it can be brought back into the HA ...
Hamish
Cirrocumulus
CirrocumulusI've always done this via the GUI... Although there used to be a command line config utility that would do it all at one go too (Not sure if that still exists). The GUI does it all in one shot, I haven't had it fail on me yet tat I can remember...
As aaron says, there's always the AOM. That works like a charm too. Very handy (Except that there's a bug when you power on, or do a full box reboot, the IP on the service processor doesn't get configured until the host is up... If the host doesn't come up, then it doesn't come up either).
Failing that, write a script & nohup it...
H
