Forum Discussion
IPv6 Route Domains
I had heard there was an IPV6 forum but couldn't find it, that is why I am asking the question here, we are on code version 11.2:
We are
building a POC for IPV6 load balancing in our network – IPV6 VS to IPV6 POOL and IPV6 VS to IPV4
POOL. We are Initially testing 6-2-4 but we have been unable to see the
VS pass on connections to the pool. When I show sys connections I get
abcd:3c00:0:1::2%3.60210
abcd:3c00:6001::1%3.80
any6.any
any6.any
tcp 2 (slot/tmm: 1/7)
http://support.f5.com/kb/en-us/solu...l7758.html
which the
above solution indicates that an LB has not be made.
We have
setup the usual VLAN, self ip, and route config but the pool member just
doesn’t get hit. We have confirmed the connection from the LTM to the
server.
Our network
build makes use of partition and as such we have built the POC in one of our
custom partition which residing within its out route domain. I have come
across an article
http://support.f5.com/kb/en-us/prod...r=22944318
which has a
note in it which sates IPV6 address must be build in the default domain 0,
“Note: All IPv6 addresses that you define on the BIG-IP
system must reside in route domain0.”
which would
not provide the functionally we would need as that would mean any IPV6 build
would need to be in the common partition in route domain 0?
I am
interrupting this correctly; any reading material on the material would be
great. I have found it hard to dig some up.
Thanks
Gus
Recent Discussions
Related Content
* Getting Started on DevCentral
* Community Guidelines
* Community Terms of Use / EULA
* Community Ranking Explained
* Community Resources
* Contact the DevCentral Team
* Update MFA on account.f5.com