Forum Discussion
jkrumenacher_13
Nimbostratus
NimbostratusiAPP Exchange 2010 deployment
I am trying to deploy 2010 in the following design.
DMZ -> BIG-IP APM will provide secure remote access to CAS
What IP address do you want to use for the BIG-IP APM virtual server? 50.50.50.1 ...
The IP address of the CAS should be the actual Client Access servers, not the IP address of the other internal virtual server.
jkrumenacher_13Nimbostratus
NimbostratusI created another iApp instance as stated above. With the same results.
( At first I read the reply stating "What IP address do you want to use for your virtual servers?" to equal 10.10.10.20 but that errors that "there is a VS already created ...." from the iApp for the internal F5)
BIG-IP LTM will load balance and optimize CAS traffic
Provide secure authentication to CAS HTTP-based services with BIG-IP Access Policy Manager - Yes, provide secure authentication using BIG-IP APM
SSL Bridging
sslclient_X
sslServer_x
Different subnet for BIG-IP VS and CAS
Servers do NOT use BIG-IP as D.G.
Fewer than 6000
use single IP for all connections
All services will be handled by the same set of CAS
use settings recommended by F5
address for your VS = 10.10.10.20 . . . IP address of the CAS 10.10.10.1
jkrum