Forum Discussion

jkrumenacher_13's avatar
jkrumenacher_13
Icon for Nimbostratus rankNimbostratus
Apr 01, 2014

iAPP Exchange 2010 deployment

I am trying to deploy 2010 in the following design. DMZ -> BIG-IP APM will provide secure remote access to CAS   What IP address do you want to use for the BIG-IP APM virtual server? 50.50.50.1  ...
application delivery
deployment
design
devops
iApps
LTM
  • mikeshimkus_111's avatar
    mikeshimkus_111
    Apr 02, 2014

    The IP address of the CAS should be the actual Client Access servers, not the IP address of the other internal virtual server.

     

mikeshimkus_111's avatar
mikeshimkus_111
Historic F5 Account
Apr 01, 2014

Just asked around a bit, and it seems that you need an iRule to perform the VIP-targeting-VIP scenario (where a virtual server forwards traffic to another virtual server on the same BIG-IP): https://devcentral.f5.com/articles/20-lines-or-less-64-vip-to-vip-redirection-url-separation-and-redirect-rewriting.Uzszxfld_0Q

 

The Exchange iApp doesn't support this. So in your situation, instead of running the "BIG-IP APM will provide secure remote access to CAS" scenario on the internal BIG-IP, you should run "BIG-IP LTM will load balance and optimize CAS traffic" again, but configure the iApp for LTM+APM mode using 10.10.10.20 as the VIP address.