how to take apart a HA config?

Hi Luca,

 

It's simple you may follow the below steps to do this. As you have not mentioned the TMOS ver. I am assuming that you are using TMOS ver. lower than 11. as it appears from your description. follow these steps

 

 

1. Unit that needs to be converted to GTM disconnect the data cables coming from you network going to this device.

 

2. Connect the cable to the MGMT port of this device go to platform section and change it to single unit, change hostname if required, change the admin and root password. Also on the VLANS remove the floating IP's as it is no more redundant system.

 

3. Don't connect this unit back unless you hae made the similar changes on the other(primary)device.

 

 

 

on the primary device.

 

1. Make similar changes in the 'platform' change it to single device if required change the admin and root pass and remove un necessary floating IP's from the unit.

 

 

Connect the other unit to the network and there you go.

 

 

Regards,