Forum Discussion
How to setup F5 LTM HA network
- Jan 04, 2018
Agree with nitass, don't use failover port. A number of limitations and basically no worthwhile advantages
I'd use both 1G interfaces that are already populated with GbE SFPs for HA, configured as LACP Port Trunk. You will need more SFPs for data though.
Observing the ports available, you cannot evenly allocate remaining ports for segregated client-side and server-side LACP bundles. So I'd bundle 2x 10G interfaces as LACP port trunk for data, and use this 20G link for both, client-side and server-side VLANs.
Here's summary
- 2x 1G interfaces directly to other unit for HA functions. Config sync, Network failover, Traffic mirror
- 2x 10G to network switch stack. All client-side and serve-side traffic
- Mgmt to network switch (ideally dedicated management switch). SSH and HTTPS (GUI)
it is hard wire failover port. i rarely use it nowadays since network failover has much more functionalities.
K2397: Comparison of hardwired failover and network failover features
https://support.f5.com/csp/article/K2397
K1426: Pinouts for the failover cable used with BIG-IP platforms
https://support.f5.com/csp/article/K1426
K15802: Revision to the hardware failover cable for certain BIG-IP platforms
https://support.f5.com/csp/article/K15802
- Shamsul_Alam_34Jan 04, 2018Nimbostratus
Thank you for your response. I will consider to implement Network fail over.
Recent Discussions
Related Content
* Getting Started on DevCentral
* Community Guidelines
* Community Terms of Use / EULA
* Community Ranking Explained
* Community Resources
* Contact the DevCentral Team
* Update MFA on account.f5.com