How to display the whole configuration of a BIG-IP with default value ?

Hi,

 

try this (CLI command):

 

"tmsh list" lists the entire config (all modules)

 

"tmsh list sys" lists the sys config

 

"tmsh list ltm" lists the ltm config

 

...

 

You can see the default configuration file here: /defaults/defaults.scf This is used when restoring the config back to factory settings.

However what I think you're looking for is the default setting options, per configuration item. Using the tmsh command 'all-properties' will do this for you.

For example, if you want to view the default setting of a virtual server, you can use

tmsh list ltm virtual  all-properties

If you want to view everything, in one command (warning, it's a lot of information) You can use

tmsh list all-properties

Compare the following outputs as an example of the additional (default) information when using 'all-properties'

user@(bigip1)(cfg-sync Standalone)(Active)(/Common)(tmos) list ltm node 1.1.1.1
ltm node 1.1.1.1 {
    address 1.1.1.1
}

user@(bigip1)(cfg-sync Standalone)(Active)(/Common)(tmos) list ltm node 1.1.1.1 all-properties
ltm node 1.1.1.1 {
    address 1.1.1.1
    app-service none
    connection-limit 0
    description none
    dynamic-ratio 1
    ephemeral false
    fqdn {
        address-family ipv4
        autopopulate disabled
        down-interval 5
        interval 3600
        name none
    }
    logging disabled
    metadata none
    monitor default
    partition Common
    rate-limit disabled
    ratio 1
    session user-enabled
    state unchecked
}