Forum Discussion
drhawkings_2156
Nimbostratus
NimbostratusHow to create full HA for WAN switch in 2 active-passive F5 LC?
Currently both F5 (active-passive) are connected to 2 ISP router.
Since both F5 needs connectivity to both ISP router 1 and 2, the connection is mesh from both F5 to both routers via a single WA...
Bart_18836Nimbostratus
NimbostratusWell I still can't see design you are mentioning, but here is how I would proceed.
1: If on that single WAN switch you have multiple vlans and you connect Bigip using trunk then on BigIP you have to use tagging for each vlan number corresponding to the number of vlan that is on the switch (tagging=dot1q tagging)
2. If you have access port on the WAN switch toward Bigip then do not use tag , just untagged interfaces.
Hope this helps.