How to configure new VIP in LB using CLI?

Citizen_elah posted a very handy method for making changes to the running configuration using the bigpipe command (aliased as b). Just wrap the outer curly braces in single quotes and you don't have to escape any of the new lines in the statement. In general, you can create one example of an object in the GUI and then check the /config/bigip.conf for the CLI syntax. You can then use bigpipe to create the object. Make sure to run 'b save' to write the config from memory to the config file.

 
 b virtual test_http_vs '{ 
    snat automap 
    pool test_http_pool 
    destination 1.1.1.1:http 
    ip protocol tcp 
    rules test_rewrite_stream_rule 
    profiles 
       test_http_rechunk 
       test_stats_profile 
       stream 
       tcp 
 }' 
 

The exact format has changed over the versions, so make sure to check your bigip.conf for the exact syntax for your version.

Aaron