Forum Discussion
CirrusHow to configure my simple website using JAVA and apply F5 Big-IP LTM to each server??
The domain name must be configured at your DNS service provider.
Say your site should be www.my-awesome-site.com, then you need configure you DNS to point to the virtual IP you configured on the BIG-IP. Or in case there is a NAT device in front of the BIG-IP, you have to use the NATed IP.
If you need to redirect to some specific URL or Directory, you can do this with LTM Traffic Policies.
If you want your site to use SSL you have to configure a clientside SSL profile and you have to have a SSL cert + private key.
On the AskF5 youtube channel there are a couple of videos regarding SSL Certificates.
CirrusHi ,
yes your right, I'm just confused because he only provided an IP for his pool member and not the URL/Domain name/Directory location of his html but still it automatically show the page.. What i plan on my lab is to create a simple website(live w/ free domain name and hostserver(infinityFree)) and integrate F5 big-ip on my web application to provide SSL Load Balancing using 3 web server on my VMWare. sorry for the noob question 😅
Renato Alcala
- Daniel_Wolf
MVP
The domain name must be configured at your DNS service provider.
Say your site should be www.my-awesome-site.com, then you need configure you DNS to point to the virtual IP you configured on the BIG-IP. Or in case there is a NAT device in front of the BIG-IP, you have to use the NATed IP.
If you need to redirect to some specific URL or Directory, you can do this with LTM Traffic Policies.
If you want your site to use SSL you have to configure a clientside SSL profile and you have to have a SSL cert + private key.
On the AskF5 youtube channel there are a couple of videos regarding SSL Certificates.
- Ren_Alcala
Hi ,
Thanks for the information 🙂 will try it on my end to see if it is worked.
Regards,
Renato Alcala
- Ren_Alcala
Hi Sir ,
Can you please help me with this if your familiar with the issue 😊. I actually planning to create an HA for both of my BIGIP servers.
Issue:
- Not all devices synced
- The time for my 1st and 2nd Big-Ip doesn't matched even though they have the same time-zone setup as Asia/Singapore.
Note: I don't know how to setup my NTP server, I just used the IP of my test server as NTP
Thank You,
Renato Alcala Jr.
- Daniel_Wolf
Follow the steps in this KB article:
K10240: Verifying NTP peer server communications
Pay attention to firewalls blocking the communication.
And test & verify also the config sync communication.
K13946: Troubleshooting ConfigSync and device service clustering issues
