Forum Discussion
Henk_Oostland
Nimbostratus
NimbostratusHalt and power on a B2250 blade
We are asked to run a EUD on one of our B2250 blades in a Viprion2400 chassis. So we have to install the EUD software, halt the system, power on the blade and run the EUD software. We downloaded the EUD software and are planning to install it on the blade, we know how to halt the blade, but i cant find a command to power-up the blade.Is pulling out of the viprion chassis and pushing it back after a few minutes the only way or is there a command to power up the blade?
2 Replies
JGCumulonimbus
The blade should power on automatically upon insertion into the chassis. See: K16992: Replacing a blade in a VIPRION system that has only one blade installed.
- JG
You can power on the blade via aom. See k14594.
