Forum Discussion
CirrusGTM's will not auto update new WIPS
I'm currently setting up a pair of GTM's that are already sync'd as LTM's. I verified both are running the same version of big3d and can run the "gtm_add" command from one device to the other. Sync and sync dos zone files are checked. I added a NTP server so both system clocks are the same, but for some reason, when I add a WIP after the initial setup, it doesn't copy to the 2nd device. I'm running 11.6. Below is an output from the primary GTM to the secondary:
[root@bigip1-11:Active:In Sync] config iqdump 10.10.3.253
11.6.0 big3d Version 11.6.0.0.0.401 linux
8506 5155 3351 1292369 547623 744746 0 10687 1 0 notice 0 0 0 0
8518 5163 3355 1293025 548055 744970 0 10697 1 0 notice 0 0 0 0
5 Replies
VFBI did notice that when I ran my command "netstat -anp | grep big3d", nothing shows up in the table as established via port 4353
- VFB
No errors. When I run the script, it adds the GTM and even gets the most recent data on it, but doesn't accept any updates. I only see the connection for iquery in my initial script run via tcpdump. My netstat output doesn't show the connections to each other via 4353.
BigD_300005Cirrostratus
Verify your servers have been created. GSLB > Servers > Server List I had a similar issue and it would not sync until I did this.
- VFB
It worked! I wished this was posted in the KB. Thanks much
