Forum Discussion

Nimbostratus

May 23, 2016

Failover just with HA interface

Hi, Actually playing with HA environment with 2 LTM, when configuring Failover, by default HA & Management address are selected and it Works correctly (active / passive), but when I put only HA...

application delivery

LTM

Hannes_Rapp_162
May 24, 2016
Active/Active status is probably caused by Port lockdown 'None' configuration on your HA VLAN/SelfIP which is the default setting. Set it to 'default', and try again. Specifying the management interface in network failover configuration is not necessary at all.

Hannes_Rapp

Nimbostratus

Active/Active status is probably caused by Port lockdown 'None' configuration on your HA VLAN/SelfIP which is the default setting. Set it to 'default', and try again. Specifying the management interface in network failover configuration is not necessary at all.