Forum Discussion

nanukanu_263047's avatar
nanukanu_263047
Icon for Nimbostratus rankNimbostratus
May 23, 2016

Failover just with HA interface

Hi,   Actually playing with HA environment with 2 LTM, when configuring Failover, by default HA & Management address are selected and it Works correctly (active / passive), but when I put only HA...
application delivery
LTM
  • Hannes_Rapp_162's avatar
    Hannes_Rapp_162
    May 24, 2016

    Active/Active status is probably caused by Port lockdown 'None' configuration on your HA VLAN/SelfIP which is the default setting. Set it to 'default', and try again. Specifying the management interface in network failover configuration is not necessary at all.

     

Hannes_Rapp_162's avatar
Hannes_Rapp_162
Icon for Nacreous rankNacreous
May 24, 2016

Active/Active status is probably caused by Port lockdown 'None' configuration on your HA VLAN/SelfIP which is the default setting. Set it to 'default', and try again. Specifying the management interface in network failover configuration is not necessary at all.

 

  • nanukanu_263047's avatar
    nanukanu_263047
    Icon for Nimbostratus rankNimbostratus
    May 24, 2016
    Thank you! Great!