Forum Discussion
NimbostratusError when trying to run ConfigSync
I have two BIG-IP 3600s that I'm trying to setup for HA. I have configured the first device and I'm trying to sync the config using ConfigSync to the second device. I have tried using "sync TO peer" on the first device, and "sync FROM peer" on the second device and I get pretty much the same error messages on both.
One of the errors in the output is saying that I have a floating address configured without a non-floating address on the same network... but I DO have a non-floating address in the same network configured. Here is the output:
Configsync Mode: Push
Transferring UCS to peer...
Installing UCS on peer...
OperationFailed exception:
Primary error : 16908289
Secondary error: 0
Error text : Error installing configuration
Obtaining results of remote configuration installation...
Saving active configuration...
Current configuration backed up to /var/local/ucs/cs_backup.ucs.
tar: SPEC-Manifest: time stamp 2014-01-07 09:10:25 is 458 s in the future
tar: SPEC-Files: time stamp 2014-01-07 09:10:26 is 459 s in the future
Product : BIG-IP
Version : 10.2.4
Hostname: UCS : DR-F5-3600-1.mydomain.org
System: DR-F5-3600-2.mydomain.org
Installing --shared-- configuration on host DR-F5-3600-2.mydomain.org
Installing configuration...
Post-processing...
BIGpipe unknown operation error:
01070355:3: Self IP ***.**.250.254 is declared as a floating address but there is no non-floating address defined for this network
Reading configuration from /config/low_profile_base.conf.
Reading configuration from /defaults/config_base.conf.
Reading configuration from /config/bigip_sys.conf.
Reading configuration from /config/bigip_base.conf.
Reading configuration from /usr/share/monitors/base_monitors.conf.
Reading configuration from /config/profile_base.conf.
Reading configuration from /config/daemon.conf.
Reading configuration from /config/bigip.conf.
Reading configuration from /config/bigip_local.conf.
Loading the configuration ...
WARNING: There were one or more errors detected during installation.
Check the error messages and take the proper actions if needed.
ERROR: UCS installation failed.
Operation aborted.
/tmp/configsync.spec: Error installing package
Config install aborted.
BIGpipe parsing error:
01110001:3: Error running config install
Checking configuration on local system and peer system...
Peer's IP address: 192.168.100.2
Synchronizing Master Keys...
Saving active configuration...
5 Replies
- JRahm
Admin
can you post your tmsh list /cm device and tmst list /cm device-group configs, as well as tmsh /cm trust-domain? Anonymized is fine.
JeffMo_140874Those commands give me this error: Syntax Error: "/cm" unexpected argument. I can't find the equivalent commands in the version 10.2 tmos reference guide.
I am running 10.2.4, is that why those commands don't work?
- JRahm
ah, you are not on an 11.x system. Nevermind. On 10.x, you can use the csTest.pl --v command to troubleshoot config sync issues. Here are some other helpful solutions:
mimlo_61970Cumulonimbus
Have you configured non-float self-ips for this network on the second device as well?
- JeffMo_140874
Sorry I made a stupid mistake. The netmask for both self-ips on that network on the secondary device were wrong. After fixing that, everything is good now.
