Forum Discussion
Greg_Burch
Jul 19, 2012Nimbostratus
Defining "loopback" address on F5
I have an LTM pair that is only physically connected to an internal VLAN. Externally-accessible virtual servers have their own IP space that is static-routed to the non-internet-routable physical addr...
Techgeeeg
Jul 20, 2012Nimbostratus
Hi Greg,
When in the Fail-over pair the only accessible IP will be the floating IP which will point to the active unit the standby unit wont be accessible. I am sure you must have configured the NAT to the floating IP of the LTM pair. Did it work or no? if it didn't then the following may stand.
I am not exactly sure but the commands bigip_add will not work from behind the NAT you have to get the LTM units the public IP address. I prefer you open a case with F5 and do share how you got this resolved.
Regards,
Recent Discussions
Related Content
DevCentral Quicklinks
* Getting Started on DevCentral
* Community Guidelines
* Community Terms of Use / EULA
* Community Ranking Explained
* Community Resources
* Contact the DevCentral Team
* Update MFA on account.f5.com
Discover DevCentral Connects