Forum Discussion
netadmindetail_
Nimbostratus
Thanks for the answer Nathan. But I cannot configure the failover settings without running the setup utility. The only thing I see in the System-->High Availability is the Fail-Safe settings. The only way I found to enable the "Ha Group" and Device Connectivity" options is by using the Setup utility.
nathe
Oct 09, 2014Cirrocumulus
I'm not in front of my bigip but i recall that in some 11.x versions if you click on High Availability then you don't see all the failover settings in the HA window. However, if you hover over the High Availability option (on the left hand side) then the arrows point to the Configsync/failover settings. In fact you should find these options if you create a Device Group I believe, even with only 1 bigip to start with. See if either of these options help. N