Forum Discussion

netadmindetail_'s avatar
netadmindetail_
Icon for Nimbostratus rankNimbostratus
Oct 09, 2014

Creating an Active-Standby Configuration without Using the Setup Utility

Hi   I want to make an active-Standby configuration with 1 LTM that I already own and a new one I've just bought. None of them give me the HA options in the GUI. The only way I can setup HA-Grou...
application delivery
availability
design
LTM
TMOS
TMSH
netadmindetail_'s avatar
netadmindetail_
Icon for Nimbostratus rankNimbostratus
Oct 09, 2014

Thanks for the answer Nathan. But I cannot configure the failover settings without running the setup utility. The only thing I see in the System-->High Availability is the Fail-Safe settings. The only way I found to enable the "Ha Group" and Device Connectivity" options is by using the Setup utility.

 

  • nathe's avatar
    nathe
    Icon for Cirrocumulus rankCirrocumulus
    Oct 09, 2014
    I'm not in front of my bigip but i recall that in some 11.x versions if you click on High Availability then you don't see all the failover settings in the HA window. However, if you hover over the High Availability option (on the left hand side) then the arrows point to the Configsync/failover settings. In fact you should find these options if you create a Device Group I believe, even with only 1 bigip to start with. See if either of these options help. N