Forum Discussion
Mondana_214537
Nimbostratus
NimbostratusCreated new vcmp guest with initial image 11.5.1, but sys software shows version 11.4.1
Hi,
I just created a new vcmp guest using the initial image BIGIP-11.5.1.0.0.110.iso, after provisioning and deployment, from the Hypervisor dashboard I see that the initial image and hotfix are correctly applied. However, from the CLI tmsh, the output is different. How is this possible? What am I missing?
[root@lb2-a-vm9:/S2-green-P:Active:Standalone] log tmsh
root@(lb2-a-vm9)(cfg-sync Standalone)(/S2-green-P:Active)(/Common)(tmos) show sys software
-------------------------------------------------------
Sys::Software Status
Volume Slot Product Version Build Active Status
-------------------------------------------------------
HD1.1 2 BIG-IP 11.4.1 647.0 yes complete
HD1.2 2 none none none no complete
HD1.3 2 none none none no complete
Below is a snampshot of the Hypervisor vcmp guest showing the image:
arpydaysweird one... any chance you could be on the wrong guest? just noticed the virtual disk name was slightly different to hostname
Mondana_214537No, it is the same device. I actually have the same issue on two devices. Thanks for your attention though.
natheCirrocumulus
Mondana,
Is what you seeing from the vCMP host? if you ssh to the guest mgmt ip address and run sow syus software you should see 11.5.1. if so then what you are seeing is just the host configuration i.e. software installed and not all the software installed on the guests.
Hope this helps,
N
- Mondana_214537
This could be it. Thank you Nathan.
- natheNo probs. Let us know if it is and mark up :-)
- Mondana_214537As soon as I can confirm it I will update it here :-)