Forum Discussion

Allim_63326's avatar
Allim_63326
Icon for Nimbostratus rankNimbostratus
Dec 22, 2009

configuring sticky-srcip in F5

Hello,

 

 

I am trying to migrate some of the VIP from CSS to F5, and I have this configuration on CSS.

 

 

content no-test.lb.pa

 

advanced-balance sticky-srcip

 

vip address 10.1.10.15

 

add service no-test.z1.pa

 

add service no-test.z2.pa

 

add service no-test.z3.pa

 

active

 

 

and I have configured this on F5 as

 

 

created three nodes with no-test.z1, z2 and z3

 

created the pool with these 3 members with load balancing method as L3 Address

 

Created the vip and assigned the pool that I created

 

 

Is there anything else that I need to configure on VIP

 

 

Appreciate your help
config
design
  • The_Bhattman's avatar
    The_Bhattman
    Icon for Nimbostratus rankNimbostratus
    Dec 22, 2009
    Hi Allim,

     

    You have a statement "advanced-balance sticky-srcip". From the F5 perspective this is persistence based on the source IP (client IP). So you will want to create Persistence profile using source affinity address as the type and then assign it on the VIP under resources tab.

     

     

    I hope this helps

     

     

    Bhattman
  • Allim_63326's avatar
    Allim_63326
    Icon for Nimbostratus rankNimbostratus
    Dec 22, 2009
    I have created Persistence profile using source affinity address as the type and then assign it on the VIP.

     

     

    Thank you so much Bhattman.