Forum Discussion

Sreevathsan_870's avatar
Sreevathsan_870
Icon for Nimbostratus rankNimbostratus
Jul 14, 2010

Configuring access to Multiple ports

Hi all     I have a problem while I was trying to configure the BIG IP HLB     I was trying to allow all the ports for access from the client to the servers behind the HLB , I have used ...
config
design
hoolio's avatar
hoolio
Icon for Cirrostratus rankCirrostratus
Jul 14, 2010
So you have the VS defined on port 0 which allows LTM to accept traffic destined for any port. But the pool members are defined only on port 80. Assuming you don't need to translate destination ports between the client request and the LTM to pool, you can configure the pool members on port 0 and leave port translation enabled. Address translation must be enabled for LTM to translate the destination IP from the VS to the pool member.

 

 

Aaron