ConfigSync issue with LTM 11.2 HF1

Thanks Steve, all posts edited.

I've just run the ping again to make sure I'm getting things in the right direction.

pinging Device2 from Device1

[root@device1:Standby:Disconnected] config ping 192.168.63.216

PING 192.168.63.216 (192.168.63.216) 56(84) bytes of data.

64 bytes from 192.168.63.216: icmp_seq=1 ttl=64 time=0.189 ms

64 bytes from 192.168.63.216: icmp_seq=2 ttl=64 time=0.168 ms

64 bytes from 192.168.63.216: icmp_seq=3 ttl=64 time=0.166 ms

64 bytes from 192.168.63.216: icmp_seq=4 ttl=64 time=0.166 ms

^C

--- 192.168.63.216 ping statistics ---

4 packets transmitted, 4 received, 0% packet loss, time 3000ms

rtt min/avg/max/mdev = 0.166/0.172/0.189/0.013 ms

[root@device1:Standby:Disconnected] config ping 192.168.11.170

PING 192.168.11.170 (192.168.11.170) 56(84) bytes of data.

From 192.168.10.170 icmp_seq=2 Destination Host Unreachable

From 192.168.10.170 icmp_seq=3 Destination Host Unreachable

^C

--- 192.168.11.170 ping statistics ---

4 packets transmitted, 0 received, +2 errors, 100% packet loss, time 2998ms

pinging Device1 from Device2

[root@device2:Active:Disconnected] config ping 192.168.63.63

PING 192.168.63.63 (192.168.63.63) 56(84) bytes of data.

64 bytes from 192.168.63.63: icmp_seq=1 ttl=64 time=0.268 ms

64 bytes from 192.168.63.63: icmp_seq=2 ttl=64 time=0.148 ms

^C

--- 192.168.63.63 ping statistics ---

2 packets transmitted, 2 received, 0% packet loss, time 1000ms

rtt min/avg/max/mdev = 0.148/0.208/0.268/0.060 ms

[root@device2:Standby:Disconnected] config ping 192.168.10.170

PING 192.168.10.170 (192.168.10.170) 56(84) bytes of data.

From 192.168.11.170 icmp_seq=1 Destination Host Unreachable

From 192.168.11.170 icmp_seq=2 Destination Host Unreachable

^C

--- 192.168.10.170 ping statistics ---

3 packets transmitted, 0 received, +2 errors, 100% packet loss, time 2000ms

So they can ping the management address but not the Self IPs.

Someone else has commented on my other post about Network > Interfaces...

On Device1, 1.1 & 1.2 are showing UP, only 1.1 has a VLAN count

On Device2 1.1 DOWN & 1.2 UP, again only 1.1 has a VLAN count

But I'm not overly sure how this is controlled.