Forum Discussion
Pinco
Nimbostratus
NimbostratusCheck if UCS restore was ok
Using REST API, I am periodically restoring an UCS in a remote disaster recovery site of some VCMP guests. The restore operation of the UCS is started, but as the REST daemon is also restarted once s...
Hi Pinco,
Maybe not quite the answer you're looking for, but have you tried using the "log" command? This way, you can receive the last 10 or so lines of ltm log and use those to confirm if there were any problems.
The following command gives you the last 10 lines of ltm log via iControl;
curl -sku admin:XXXXXXXX -H "Content-Type: application/json" -X GET https://XX.XX.XX.XX/mgmt/tm/sys/log/ltm/stats?options=lines,10
More info on the log commands via iControl: https://support.f5.com/csp/article/K41550738
Hope this helps.
AlexBCT
Cumulonimbus
CumulonimbusHi Pinco,
Maybe not quite the answer you're looking for, but have you tried using the "log" command? This way, you can receive the last 10 or so lines of ltm log and use those to confirm if there were any problems.
The following command gives you the last 10 lines of ltm log via iControl;
curl -sku admin:XXXXXXXX -H "Content-Type: application/json" -X GET https://XX.XX.XX.XX/mgmt/tm/sys/log/ltm/stats?options=lines,10
More info on the log commands via iControl: https://support.f5.com/csp/article/K41550738
Hope this helps.
PincoNimbostratus
NimbostratusThank you Alex and Pete for your help. I will try this solution, if I remember well there a "magic" log entry that says "UCS installed".