Forum Discussion
ASF
Altocumulus
AltocumulusBIG-IP VE VMWare Cluster HA triggering configuration
Hi, this is my first step into BIG-IP VE deployments (always viprion so far). I have all my test clusters up & running in a VMWare environment: Active/Stanby using dedicated vNIC&VLAN. 4 vNIC per...
Hi ASF ,
I think you might need to consider some questions around the failsafe topic, including what your expected failure scenarios might be. For instance, in a virtual environment I'd say the chances of losing the VLAN near to the interface of the VE are low, but something like a missing gateway or an upstream connection might be a greater risk. You should also only configure VLAN failsafe on the vlans that truly matter.
The other option, gateway failsafe, can monitor one or more upstream gateways, depending on the architecture. https://support.f5.com/csp/article/K75303031
HA Group builds on gateway failsafe but can work at the traffic group level, should you have a need for that level of control. https://support.f5.com/csp/article/K42542000
Hi ASF ,
I think you might need to consider some questions around the failsafe topic, including what your expected failure scenarios might be. For instance, in a virtual environment I'd say the chances of losing the VLAN near to the interface of the VE are low, but something like a missing gateway or an upstream connection might be a greater risk. You should also only configure VLAN failsafe on the vlans that truly matter.
The other option, gateway failsafe, can monitor one or more upstream gateways, depending on the architecture. https://support.f5.com/csp/article/K75303031
HA Group builds on gateway failsafe but can work at the traffic group level, should you have a need for that level of control. https://support.f5.com/csp/article/K42542000