For more information regarding the security incident at F5, the actions we are taking to address it, and our ongoing efforts to protect our customers, click here.

Forum Discussion

hotrod_127503's avatar
hotrod_127503
Icon for Nimbostratus rankNimbostratus
Jan 04, 2005

Best Practice for Sync Between Primary and Failover

I am writing an auto-registration service that will allow machines to add themselves to the Load Balancer. Due to the transactional nature of this process, I am never quite sure when everyone is regi...
dev
devops
iControl
gerald_wegener_'s avatar
gerald_wegener_
Icon for Nimbostratus rankNimbostratus
Feb 27, 2009

 

I have this problem using pyControl when I upgraded from 9.3.1 to 9.4.5. I would get no response using either of the pyControl commands below for config sync. After I ran this if I then tried to do a manual config sync that would fail as well and I was forced to reboot the box.

 

 

After I found this thread I tried the recommended command on both the active and the standby box but the problem persisted with 9.4.5. I then upgraded to 9.4.6, applied the commands again but I still have the same problem.

 

 

Any idea's on how this can be fixed?

 

 

These are the commands I'm using running 9.4.6(both fail)

 

 

Thank You.

 

 

 

b.System_ConfigSync.synchronize_configuration(sync_flag = 'CONFIGSYNC_ALL')

 

b.System_ConfigSync.synchronize_configuration(sync_flag = 'CONFIGSYNC_BASIC')