Forum Discussion
Roman_Melekh
Altocumulus
AltocumulusBackup F5 BigIP using RestAPI and PowerShell (again?)
Hello! I went through the Forum and I saw a lot of related messages but none of them actually answered my question. The documentation [I found] leaves to be desired and I hope that the community is ...
okay, I did that: https://stackoverflow.com/questions/76230777/bigip-f5-ucs-backup-via-restapi-and-powershell/76231795#76231795
Working on the last step - how to delete a file from UCS when it is downloaded.
Then - how to upload it to SharePoint, but this is another story and already completed 🙂
Paulius
MVP
MVPRoman_Melekh I would rather run the backup process locally on the F5 rather than having a device run remote commands and copy files off. You can do this all using the following link with the only catch being that every time you run a code upgrade you will most likely have to set it all up again. Luckily if you setup a step by step guide to this it should be easy enough to run each time you perform a code upgrade since they don't typically happen too often. You will need to know which remote system you will be copying your backups to but that should be easy enough.