Forum Discussion
NimbostratusASM policies not synced
Hi everyone,
I have a query related to ASM configuration sync I am running Tmos 11.6 with latest HF. I have LTM configuration running perfectly fine on my units n Sync works completely fine but the ASM configuration is not syncing between the units properly. On active unit I have 8 policies but on secondary it shows only 5 also on active unit there policies r blocked but on secondary same is transparent, how I can't figure out. Has someone faced similar issue? What could be the possible solution of this?
Regards,
12 Replies
natheCirrocumulus
Have you configured an ASM synchronisation group?
TechgeeegHi Nathan,
Yes its configured once synced all the status on the two boxes shows green status.... but the configuration difference is really something alarming
Regards,
- natheYou could try removing the policies from the standby and then doing a new sync? Create a ucs first though. Anything in the ASM log when you sync?
Techgeeeg_28888Hi Nathan,
Yes its configured once synced all the status on the two boxes shows green status.... but the configuration difference is really something alarming
Regards,
- natheYou could try removing the policies from the standby and then doing a new sync? Create a ucs first though. Anything in the ASM log when you sync?
- boneyard
MVP
did you have time to try what nathan suggested?
have you checked the asm log for indications of problems? i did experience similar issues in the past, but usually they went away after a restart.
- Techgeeeg
Well I have checked the logs and it is showing no error.... so u mean shall I give a restart to the secondary device??
- boneyard
if you perform a sync now, do you see anything in the asm log?
if you make a change in the ASM policy and perform a sync do you see anything in the asm log?
- Techgeeeg
Hi Boneyard,
There was no sync happening between the two units and it was very complicated, the VS were created using the iApp and the HTTP compression is not license was an error showing up later which was causing the boxes not to sync the configuration completely.....
Regards,
- boneyardthank you for explaining the cause, not sure if you can flag your own question as answered.
- Techgeeeg_28888
Hi Boneyard,
There was no sync happening between the two units and it was very complicated, the VS were created using the iApp and the HTTP compression is not license was an error showing up later which was causing the boxes not to sync the configuration completely.....
Regards,
- boneyardthank you for explaining the cause, not sure if you can flag your own question as answered.
