ARP/MAC Tables Not Updating on Core Switches After F5 LTM Failover (GARP Issue?)

We have finally resolved this issue and as promised I said I would comment on what the issue was. We confirmed 100% with a tcpdump on the F5s that they were sending Gratuitous ARPs out its 10G interfaces for all virtual-addresses after a failover event.

We opened a TAC case with Cisco and found that there is a hardware rate-limiter in place on the particular F1 card (very old card) that these F5's were terminating into. The rate-limit for class rl-4, which ARP was assigned to was set to 100 packets-per-second. This is way too low to support the amount of ARP traffic the F5 generates and we had millions of ARP drops on this particular card.

We analyzed the pcap file and found the rate at which the F5 transmitted these GARPs and adjusted the rate-limit on the rl-4 class to 3000 packets per second. We performed failover tests and the MAC addresses on both 7Ks updated immediately for all virtual-addresses.

Thanks for all the input you guys provided.