Forum Discussion

MW1's avatar
MW1
Icon for Cirrus rankCirrus
Sep 06, 2010

Adding standby F5 to HA pair using network failover

All,   can anyone advise why when I add a standby F5 LTM to a active/standby HA F5 LTM setup using network fail over the interfaces on the active F5 go offline after the device "see each other"...
config
design
nitass's avatar
nitass
Icon for Employee rankEmployee
Jul 10, 2012
can you please help me , how should i configure them and hoe to test fail-over conditions, is there should be always connection between 2 devices to act in active / standby state...how to achieve in this caseyou have read redundant configuration guide, haven't you? is there any specific topic there you do not understand or it is not clear? it might be easier to assist.

 

 

Manual: BIG-IP Redundant Systems Configuration Guide

 

http://support.f5.com/kb/en-us/products/big-ip_ltm/manuals/product/tmos-redundant-systems-config-11-2-0.html