Forum Discussion

MW1's avatar
MW1
Icon for Cirrus rankCirrus
Sep 06, 2010

Adding standby F5 to HA pair using network failover

All,   can anyone advise why when I add a standby F5 LTM to a active/standby HA F5 LTM setup using network fail over the interfaces on the active F5 go offline after the device "see each other"...
config
design
Chris_Miller's avatar
Chris_Miller
Icon for Altostratus rankAltostratus
Sep 06, 2010
What interfaces are you using for network failover? Just the management interface? Since the active is itself failing over, I imagine we're triggering one of our failsafe conditions, be it gateway, VLAN, or a service.

 

 

What do you have defined as far as failsafe goes...vlans? gateway? ha-groups? etc...Also, are you using preferred redundancy state at all?