Hi All, I need to configure VS in LTM environment with four new pool members which are on 10.12.12.0/24 subnet. At present, I cannot see any route matching for that subnet in the route list in F5. Flow of current set up can be shown below F5 --->trunking vlan 10,11,12--->Layer 2 switch---->Layer3switch, SVI v10 10.14.10.1---->Cloud--->Pool members I can see via traceroute command Pool members are reachable from F5, but the route is going via mgmt-ip. So do I need to create a static route in F5, so when F5 will try to communicate the pool member it wont go via its mgmt IP.

on the VS use SNAT automap so that return traffic from the pool members is sent via F5.

Forum Discussion

m1978_295079

Nimbostratus

May 26, 2017

Adding routes for Pool members

Hi All,

I need to configure VS in LTM environment with four new pool members which are on 10.12.12.0/24 subnet. At present, I cannot see any route matching for that subnet in the route list in F5. Flow of current set up can be shown below

F5 --->trunking vlan 10,11,12--->Layer 2 switch---->Layer3switch, SVI v10 10.14.10.1---->Cloud--->Pool members

I can see via traceroute command Pool members are reachable from F5, but the route is going via mgmt-ip. So do I need to create a static route in F5, so when F5 will try to communicate the pool member it wont go via its mgmt IP.

BIG-IP

cloud