Need to Re-ip the VIPs, Self-ips and mgmt IPs
Hi Experts, I have following requirement: I have to re-ip some VIPs which are currently on 4.x.x.x/24 network to 10.x.x.x/24. Can I reconfigure the old VIPs with new IPs I have self-ip(static and floating) in External and Internal Vlans , which are also need to be re-ip to 10.x.x.x/24 segment. Can I change the IPs or do I need to create new self-Ips for external and internal VLans. I have a default route on my LTMs pointing to L3 switch : list /net route all-properties net route /Common/Gateway { description none gw 4.x.x.1 mtu 0 network default partition Common } Do I need to delete this default route and create a new route which will be a L3 SVI in 10.x.x.1 Can I keep the old default route and create a new for 10.x.x.1 , will that work. Can I use forwarding VIP. Also if I remove the old self-ips and the old default G/w , will it create any outage.. I am planning to do the configuration changes on Standby device first and then make it as Active and once tested successfully, I will sync the devices. Kindly assist.. It will be great help and much appreciate it !
F5 Forwarding (IP) VS, VLAN and tunnels setting
Hi, When configuring a Forwarding (IP) virtual server there is an option to enable the VS only on certain VLANs. Does this apply to the source traffic, the destination traffic or both? Say I have the following topology: -------- ------ ------- Internet | Vl10 | <--> | F5 | <--> | Vl20 | My servers -------- ------ ------- Ext Int If I create two Forwarding (IP) VS's (restricted by src/dest IP), one for inbound traffic and one for outbound traffic, will I have to configure the VS to be Enabled on both VLAN 10 and 20 for both of them? Or will I just enable the inbound VS on VLAN 20 and only enable the outbound VS on VLAN 10? Cheers, Rich