Forum Discussion
CirrostratusWhy use mgmt port to monitor ?
Michaelyang ,
I know you are following F5 Articles , add specific route in F5 it self such as below :> add this Route as a Specific , not as a default route on F5.
> Also Make sure with the Connectivity between traffic subnet "10.20.10.0" and Management subnet "10.20.54.0"
> you are adding default Route and at the same time F5 see real server directly connected with it through managment vlan , So F5 prefer Management Network over TMM.
> Add this Specific Route and Put this Command
#ip route get 10.20.54.2
you should see this real server ip by self address from "10.20.10.0" TMM subnet.
Regards
Cirrostratus感謝您的回复。
這是我的結構：
F5：
mgmt：10.20.54.1/24
vlan_ip：10.20.10.1/24
默認路由：0.0.0.0/0 10.20.10.254
Real Server:
IP: 10.20.54.2/24 進行
這些設置後，監控服務器的端口為mgmt。
但是我設置的默認路由應該不會去vlan口吧？
我正在按照 F5 文件進行操作，TMM 路由無論如何都將優先於 mgmt 路由。
https://support.f5.com/csp/article/K13284
Michaelyang ,
I know you are following F5 Articles , add specific route in F5 it self such as below :
> add this Route as a Specific , not as a default route on F5.
> Also Make sure with the Connectivity between traffic subnet "10.20.10.0" and Management subnet "10.20.54.0"
> you are adding default Route and at the same time F5 see real server directly connected with it through managment vlan , So F5 prefer Management Network over TMM.
> Add this Specific Route and Put this Command
#ip route get 10.20.54.2
you should see this real server ip by self address from "10.20.10.0" TMM subnet.
Regards
