Forum Discussion
Parveez_70209
Nimbostratus
NimbostratusVLAN FAILSAFE QUERY
Hi,
We are planning to enable VLAN Failsafe into our environment.
Our environment is into Active-Standby LTM setup.
As we are enabling VLAN-FAILSAFE in both the boxes Primary and Secon...
boneyard
MVP
MVPassuming v11, this is a full box failover, it doesn't failover a single traffic group.
2 can make some sense, although if a failover happened from unit 1 to unit 2 and unit 1 is still not ok then a failover back to unit 1 wouldn't happen. it wouldn't matter a lot either assuming you configure vlan failsafe on the important vlans, if there is no traffic the system just doesn't work.
I believe that sol is more focused on preventing reboots (if you configure vlan failsafe like that, it is the default) for a secondary unit if it becomes isolated.
